At the transformer installation site, some tips for transformer oil dehydrator process:
Double stage Transformer Oil Filtration Equipment
DVTP Transformer Oil Dehydrator Plant
- 1).Fences and warning signs should be set up in the transformer installation and construction area.
- 2).Fireworks are strictly prohibited in the transformer construction area, and sodium carbonate dry powder fire extinguishers are provided on-site.
- 3).Before filtering oil, it is necessary to check that all equipment and components are reliably connected to the ground wire.
- 4).Detailed technical handover and safe handover should be done before construction. Operators should be familiar with equipment operation and construction procedures.
- 5).When the oil pipeline is connected, it must be tied firmly to prevent oil leakage and oil running.
- 6).During the filtration of transformer oil, the on-duty personnel should inspect the equipment status and oil system status, and make records. 7. When receiving the incoming oil, calculate the total amount of incoming oil, allocate the flushing oil and installation oil, try to avoid wasting oil, and ensure that the transformer is filled with oil at one time.
- 7).When receiving the incoming oil, calculate the total amount of incoming oil, allocate the flushing oil and installation oil, try to avoid wasting oil, and ensure that the transformer is filled with oil at one time.
- 8).Oil inspection is an important task. Since there is no better on-site inspection method at present, it can only rely on the experience of the on-site personnel to judge its visual inspection and smell. This work should be carried out by experienced workers.
- 9).In the process of transformer oil dehydrator plant, the inlet door of the oil storage tank should be sealed with a plastic sheet. The bottom of the installed moisture absorber should be filled with enough oil according to the scale line.
- 10).The oil temperature at the outlet of the oil filter should be at least 50°C, and the highest should not exceed 70°C.
- 11).Pay attention to the oil quality of the vacuum pump, and replace the vacuum pump oil in time.
- 12).Pay attention to observe the oil level of the oil accumulation window of the oil purifier machine, and stop the transformer oil dehydrator machine in time.
- 13).Pay attention to the pressure gauge on the top of the filter elements, and replace the filter in time.
- 14).When the oil pipe is not in use, it should be tightly sealed with plastic cloth immediately to prevent moisture and impurities from entering the pipe.
- 15).After filtering the oil in the oil storage tank, seal the outlets of the oil tank tightly with plastic cloth in time.
- 16).Before turn off the oil purification machine, first turn off the heater. In order to prevent the heater from burning empty and damage.
ASSEN is an oil purifier manufacturer in Chongqing city, China. If you have any requirements, please don’t hesitate to contact us. Tel:+86-23-88703683 Email:[email protected]